| PROPERTY |
TEST Method |
EN 13911 REQUIREMENTS |
RESULTS OBTAINED |
| 6.1.2 Flame Spread |
EN ISO 15025: 2002 Method A |
EN 533 Index 3 with no hole formation in any layer. |
No flaming to edge
No hole formation
No flaming or molten debris
No afterflame
No afterglow
i.e. EN 533 Index 3 |
| 6.1.2 Flame spread (test flame to inner fabric) Only applies if inner fabric is different |
EN ISO 15025: 2002 Method A |
EN 533 Index 3 with no hole formation in any layer. |
No flaming to edge
No hole formation
No flaming or molten debris
No afterflame
No afterglow
i.e. EN 533 Index 3 |
6.1.2 Flame Spread
(seams) |
EN ISO 15025: 2002 Method A |
No specimen containing a seam shall permit the seam to open |
Two seamed specimens tested. Results as above with no splitting of seam |
| 6.1.3 Heat transfer (flame) |
EN 367: 1992 |
HTI24 ≥ 8s
HTI24 – HTI12 ≥ 3s
(based on lowest result) |
HTI24 =
HTI24 – HTI12 =
Quote lowest result |
| 6.1.4 Heat transfer (radiation) |
EN ISO 6942: 2002
Method B at 20kW/m² |
t24 ≥ 11s
t24 – t12 ≥ 3s
(based on lowest result) |
t24 =
t24 – t12 =
Quote lowest result |
| 6.1.5 Residual strength |
EN ISO 6942: 2002
Method A at 10kW/m² |
Burst strength
(EN ISO 13938-1: 1999) ≥ 300kPa |
xxkPa |
| 6.1.6 Heat resistance |
ISO 17493: 2000*
at 260°C |
Materials shall not melt, drip, ignite or break. Shrinkage ≤ 10% |
Fabrics did not melt, drip, ignite or break.
Max shrinkage:
Outer fabric
Inner fabric |
| 6.1.6 Heat resistance |
ISO 17493: 2000* at 260°C |
Materials shall not melt, drip, ignite or break. Shrinkage ≤ 10% |
Fabrics did not melt, drip, ignite or break.
Max shrinkage:
Outer fabric
Inner fabric |
| 6.1.7 Seam breaking strength |
EN ISO 13938-1: 1999 |
Burst strength ≥ 450kPa |
xxkPa |
| 6.1.8 Dimensional change |
EN 25077: 1994 |
Max ±5% (- = shrinkage) |
|
| 6.1.8 Dimensional change |
EN 25077: 1994 |
Max ±5% (- = shrinkage) |
|
No.9-22, Tongwen Ln., Yuchi Township, Nantou County 555, Taiwan (R.O.C.)
+886-49-2899101
service@oxinforce.com.tw
Contact
Send your specification
mark can then be affixed to the approved equipment.